Thread: power Management Setup

ACPI function

Default: Enabled

When Enabled, this function can save the power of your system.

Power Management

Default: User Define

This category allows you to select the type (or degree) of power saving and is directly related to the following modes: Doze; Standby; Suspend; HDD. Power Down.

Video Off Method

Default: DPMS

This determines the manner in which the monitor is blanked. VjH SYNC + Blank. This selection will cause the system to turn off the vertical and horizontal sync. ports and write blanks to the video buffer Blank Screen: This option only writes blanks to the video buffer DPMS: Initial display power management signaling.

Video Off In Suspend

Default: Yes

This determines the manner in which the monitor is blanked.

Suspend Type

Default: Stop Grant

Select the Suspend Type. The choice: PWRON Suspend, Stop Grant.

MODEM Use IRQ

Default: 3

This item determines .the IRQ in which the MODEM can be used.
The choice: 3, 4,5,7,9, 10, 11, NIA

Suspend Mode

Default: Disable

If you have selected User Define for the Power Management item, you can set this item to a selection of timeouts from 20 seconds to 40 minutes.

H DD Power Down

Default: Instant-off

When enabled and after the set time of system inactivity, the hard disk drive will be powered down while all other devices remain active.



Soft-off by PWR-BTTN

Default: Instant-off

Under ACPI (advance configuration and power interface) the system can be turned off mechanically (by the power button) or it can undergo a software power off. If the system has been turned off by software, the system can be resumed by a LAN, MODEM or ALARM wake up signal. This item allows you to define a software power off using the power button. If the value is set to Instant-Off, the power button will automatically cause a software power .off. If the value is set to Delay 4 Sec. the power button must be held down for a full four seconds to cause a software power off.

Power On by Ring

Default: Disabled

Enabled: When system is in suspend mode, it can be woken up by modem.
Disabled: It cannot be woken up by modem.

Wake Up On LAN

Default: Enabled

If you have installed LDCM administrator software, and any client side is powered off, you can wake up by LAN through the LDCM mechanism.

Resume by Alarm

Default: Disabled

When Enabled, two additional lines will be added to the screen Date (of Month) Alarm; Time (hh:mm:ss) Alarm to let user set the desired date and time. After power off, the system will automatic power on at the specified date and time.

Reload Global Timer Events

When enabled, an event occurring on each device listed below restarts the global time for Standby mode.
IRQ[3 -7,9-15],NM;

Primary IDE 0;

Primary IDE 1;

Secondary IDE 0;

Secondary IDE 1;

FDD, COM, LPT Port PCIPIRQ[A-Dj #