Thread: Fatal Exception error

How to fix a fatal exception error?

Hi

First Remove all TSRs, halt or discharge any TSRs or programs which are being presently running before running the program or attempting to restore the error.

Hi

Try Running Scandisk / Defrag on the hard disk drive as it could be possible your hard disk drive may also issue an causing the substitute file or the data files to become corrupt or invalid

Hi

I think you should try Disable External Cache in CMOS, if option is available, then attempt to enter your computer's CMOS setup and stop the exterior supply. If this resolves your issue it is likely that you are encountering a heat which is related to issue.

Hi

Then it might be a Heat related issue, see to it that all the fans in and on your computer are working properly. Perhaps try to attempt for an additional case fan, if there space is available in the CPU.

Hi

Might be you have overclocked any of the machinery which is within the computer, and then try to set the computer to its factory settings so that it can verify the overclocked part that it is creating any kind of issue.

Hi

Try Updating your software or check for software patches, if you are still facing invalid page faults in only one program, then confirm first that the software program is well-matched with the operating system which you are running and the program within. Also make confirm with the manufacturer of the software program that there are no available patches or updates for that program which may resolve your problem.

Hi friends get in trouble

The best thing first you Verify your computer has more than 200 MB available, if the computer is running very low on a hard disk space, your Windows swap file will be not able to increase the size which is been needed, and resulting the programs to be swapped in between the memory and the hard disk drive more often. When this activity takes place then it is more likely to a GPF which can occur.

Hi

Recently installed software or hardware is installed then reinstall or uninstall it and check with it that this installation is causing any problem to the computer.

Hi

See that the CPU Core Voltage is available in the computer then confirm it with the CMOS or by the jumper in order to see the factory requirement. This will also demand you to consult with the motherboard manufacturer.

Hi

See that sometime bad memory can also result into fatal exception. And if there is any memory which is been added recently to the computer then you must first remove it and verify that the memory is not causing the problem to the computer.

If no memory has been recently added to the computer and you have try all the above recommendations given to you.