Thread: Intel-OL

Tell them that we bought recently (me and my father) pc again, but after a long time to be with AMD, this time we changed sides.
The computer is as follows:

ECS P35T-A
Intel E7200
Stock Cooler
ATI X1650 Pro -> was cheap (30 Luke) and I was under, but I hope soon to buy the 4850
2 x 1 GB Dual 800 MHz Super Talent

The other ingredients were kept from the previous one.

The thing is that after reading a bit here in the forum, I decided to slightly overclocked processor ... As the plate is not as ocera from what I read; I used to do something modest. After testing several configurations of FSB, Vcore, etc ... I arrived at the following, which did not meet my goal, but came up a lot.

The first thing I did and I thought it had been stable since he ran a few super pi than two. But later when I was playing carbon and burn a DVD from the disk, I threw the win blue screen of death and the pc restarted, I realized that was not stable XD.

1.35 Vcore
FSB 310
VDIMM 2.0
Memos 800

As the procedure cache and the plate will give the OC, I got the frequency for which the memos were not as high.

1.35 Vcore
FSB 340
VDIMM 1.9
Memo 667 (851)
so the process I was about 3228 MHz. 2530 of which are original and reports 851.

My idea was to make the process at about 3400 MHz about on the subject of temperature, since it is already up there too with the stock cooler. Any idea how to setup to run because I have made some changes but not me, not even the pc da video. We will have to change trimmings of RAM, now with the last OC I put up at 5-5-5-15.

Oc is very good, always with a proven stable over time, it is more reliable.

I am sure that these reports can give more than 851 MHz, so you should try to see the issue to see if its voltage raises more.

Thanks for your opinion and suggestion, a question, when it is necessary to increase the trimmings of the memos? I was trying various options, raising the voltage of the memos, but still give me no more OC.

Leave a safe margin, as 6-6-6-18 or 5-6-6-18 or maybe more, in my 6 in the CL I do not work, not why, but maybe to you if, after a subis low voltage and try to see if they handle the next step. If you start to hold down these latencies and ready.

Gives me no more, me it is the fault of the source XD, so leave it there just as the OC, as the psu is a generic...

18th IS, does not work for both.
500 o 550w, you must have 2 rails for 4850 and something like 500 or 550W to be sure.

What source I recommend that they do not escape either the price at most 35 Lucas
a refieres con 2 rieles? What you mean with rails 2?

Thank's

I never thought that as many as I could overclokiar me and never given the luxury of doing as I have an e8400 I deve never anything XD ...

The Celeron is the only CPU to not care about anything, temperature, frequency, or voltage (being humanly reasonable, do not put 3v XD).

XD I missed something.

Further according to the manufacturer (Intel), voltage ranges from 1 to something around 1.36.

Mine says 1.35 max according to them, but the world record is 1.7 to 2v XD (do not try this at home).

The source is not limiting you (reviving a couple of post on this motherboard), but the plate may be taken with latencies a play but I have tried everything to increase the fsb over 350 but it seems like some people said and elsewhere by this bloke bios.
Software but then prove to me that frequencies both pci and cpiex were very high.