The version of the coaxial cable used by cable using the old Ethernet standard for twisted pair Ethernet network communications. The Xerox 1973 Ethernet were created. It is the most widely used standard in network communication, faster version of the horizon in the second (1 Mbps megabytes 1000-10) run.
Standard IEEE 802.3 Ethernet has been, in several types and versions used the original version 10base5 start. Description and standing 10 to 10Mbps using the base for the base-band communication. Distances up to 500 before the signal can travel up to 5 meters or stand to play repeatedly. Instead of using the latest version of the twisted pair wiring coaxial cable using the Ethernet type. Other types of Ethernet 10Base2, 10BaseT and is being used 100BASE - T is a common type of today's standard. 10BaseT and 100 m distance, depending on the offer, 100 Mbps and uses twisted pair cables.
Packets at the network computer and is not to deny the sending of the destiny of all the public computers on the network segment of the packet to another computer to retrieve the packet. If you are) all the computers in this case the band (which received the packet network to a great start to take its toll on the node. If the switch node are picked up by every transmission before it reaches the switch Ethernet. switches on the appropriate data reaches its destination segment of the data transmission purposes only.
used to send and receive data in use today are both allowed to move in one direction at a time only half of the data devices, older systems can be at most of the network.
CSMA / CD (Carrier Sense Multiple Access with Collision Detection) packet was introduced to stop the clashes in the wires to send data simultaneously to multiple computers. Before sending station, and listen to them / and if the quiet in the middle of the cable or other transmitting station, the station is known, the data transfer. For the two segments is called a collision domain collision a single generating station can be transferred simultaneously.
and Ethernet network or a large segment is often classified as a collision to a minimum. To stay in the subnet that is sent to a different subnet unless the computer is sent a packet to its own subnet. And take the appropriate subnet router to forward packets. How is the destination address in packet determines the packet to subnet the IP-based network.
Currently the most common uses Ethernet Category 5 cable (or CAT5) UTP . A twisted pair cable type and wire cable uses four pairs. And sending data sets are used The2 used to receive data sets. It also shielded twisted pair (STP) is a shield that is difficult and expensive to work. For CAT5 cable to the phone cord with RJ connector is only visible to the larger 45 connector. For CAT5 there is only 100Mbps standard Cat5e cable CAT5 support 1GBMbps to support a new type of connection. Of Cat5e and Cat6 is a higher standard in the 100MHz, 250MHz is the same except for increased bandwidth.