Thread: Influence of PCI versus 6 +6 8 +6 in graphics

I correct: used peaks and very high loads, but in many graphics tend to be to give more room for c and caution tochas be lost in charges, and perhaps in minimal. but that in extreme cases, whenever you use the adapter should not pass anything I guess I wonder why you see a card like that, no?

I ask because my source has 6 +6 and 8 +6. I have no adapter .... and I wondered if would affect something as it is imminent that you upgrade to a GTX 580 or a 7970 if they continue to fall at that rate.

According to the chart I have understood if there is need to put him 6 +8 6 +8, you can not put a 6 +6 pin connector because they are the same. Would have to buy an adapter to 8 pin molex to connect, although I have never known if the power rails are not used, but if the molex to get that power if done right because it is supposed that the rails are better prepared for that job.

For that source seriua good to know that you have and how they are distributed loads on the rails. Usually nothing happens, but hey, it's always good to know the data. I have myself 4railes with 18A and one of them I have connected the hdd and 2 6pin connectors, one for graphics so takes 6 months and see haha .

In a graph with 6 +8 you stick 6 +6, I think that 2 more contacts have to be yes or yes to boot, not esque fall short and go.