Try a different graphic just in case, If you have integrated VGA, remove the Zotac and try to see if you start by VGA.
Hi, I have a 1GB ZOTAC GTS 250, the other day when you turn on the PC, the graphic is placed at 100% fan speed and shows no image, the monitor stays black, can be of the graph?
Try a different graphic just in case, If you have integrated VGA, remove the Zotac and try to see if you start by VGA.
The problem is that I have another graph to test, and the plate is old and does not have built, I'm thinking about taking a baratita if only to get by, but I sure like that before and have some other opinion, i tried to disassemble, clean a little, clean.
But I think if you have petado if it starts to boot, but it gets to 100% and no signs has all the earmarks of the graphics, although it may be the motherboard have you noticed if leaving it on makes noise entering the commands windows? If you have to change, be careful what you buy in nvidia, all now sold under 100 e, is less than your GTS 250.
If the board has the speaker plugged in and no beeps, not the GPU, put the speakers and let the PC booting to see if it hits the OS.
The pc boots up fine, the hard disk creaks and works until they think and load windows, i bought another chart, I hope that well guys, I came this morning that caught gts it rides and running around normally, now I have to pull warranty to see if the ZOTAC give solution.
Bookmarks