Thread: SCSI hard drives

Fall into the hands of a new SCSI disk to replace hot-swappable drive off in the server.

I looked at him, and do not see any jumper to set the ID. And how to set ID? Or now do not use ID?

Explain the situation…

If you drive to the connector of SCA (80-pin), a SCSI ID usually is set by the basket, not drive, so you do not need it.

Thank you!

Or, if you still have a hard jumper, then when you install to Cart they are ignored?

That is, why on hard with jack jumper for ID?

No. SCSI ID is determined by closure of the four lines, closed state of a unit. If you close and on the basket, and the HDD, will still be a unit in discharge.

In the event that you do not trash. A coupler. In any case, h, we suggest that you do not change and simply insert the hard drive to the basket. If not work, then may be further discussion and action.