Many PC hardware items come with logo symbols, designed to be fixed to front of PC tower as a means of displaying off hardware that is in. If you want to install a logo on PC case, the two hurdles that you want to beat are making a clean surface for adhesive to stick to and ensuring that logo is not curved. Clean PC tower and utilize masking tape as a guide to make sure logo is installed appropriately.

Instructions

1. Step 1

Dampen a cotton ball with rubbing alcohol. Utilize cotton ball to clean region where logo will be installed. This will take out any surface dirt that causes the logo to stick badly. Permit rubbing alcohol to dry before ongoing.

2. Step 2

Search a vertical line on PC tower to utilize as a guide. E.g. you want to utilize one side of floppy drive. Line ruler up against guide, and place a strip of covering tape so that it is wash out with ruler.

3. Step 3

Search a horizontal line on PC tower. A guide to utilize for this an air intake vents or bottom of floppy drive or another drive. Line the ruler up with guide, and put down other strip of covering tape. You must now have two strips of making tape forming a cross on PC case, with four 90 degree angles in center.

4. Step 4

Unwrap backing off of the logo and attach it firmly to PC tower. Two sides of button must be lined up with sides of one of 90 degree angles of masking tape cross, so that it will be straight when tape is removed.

5. Step 5

Unwrap the covering tape off PC tower.