Thread: Monitor will not work after PC assembling

Hello friends, 460 braucht the additional power, you have the right cable plugged in or they will range only in the slot?

I am of course the 2 x 6 pin plug fitted to it, the two LEDs light up on the board too, so she gets in any case current, it was not really done much to it replaced, except just the thermal paste and clean the cooling fins, Greeting.

Changed thermal paste the video card I would imagine this might be something went wrong, would be either the VGA test in your PC or validate your VGA in another PC so the fastest to be implemented approach if all the wiring checked immediately and for Ok found .

What should it go wrong, did the chip and the cooler made with ArctiClean clean, neutralized, and applied new paste on the chip, I build my PC is not the first time apart, so it's not. I just never had this problem, and since I have not done anything great on the boards, and I've had grounded every time before I bolted to the card or the motherboard, I can exclude a short-circuit really well.

Hi, in connection with paste / GPU / exchange brought just one more way that I just share, when the beep at the beginning of normal is located, it IMO somewhere in the range Graka & Monitor. And if you have a short circuit and improper handling can exclude, it is perhaps just a coincidence or bad luck that just at the "tinkering" one or the other component is evaporated.

The Beep is not hard work, however, makes noise, I took the cpu for a short period from the MB, it is possible that in the BIOS settings or reset other configurations, greeting.

Only if you take the battery for a certain period ausm Board, if ever any beep signal, if the beeper at all connected, trying times with only one ram bar to start, if necessary, test times, all bolts / benches by.