Thread: Problema en placa base EX58 Extreme

Hello, I am raising my situation to say that I think if, like me, the problem comes from the motherboard manufacturer:

Tengo una GA ex58 Extreme con un i7 920 y una tarjeta grafica bfg 260. I have an ex58 GA i7 Extreme with a 920 and a BFG graphics card 260.
Acabo de montar el ordena con una fuente de alimentacion de 700W la Tacens Valeo II, la cual he verifacado que funciona porque la he usado una semana antes con un Pentium D y la grafica que puse antes. I just ordered the mount with a power supply of 700W the Tacens Valeo II, which I verifacado that works because I used a week earlier with a Pentium D and the graphic that went before.

El caso es que una vez montado lo enciendo e inicia perfectamente pero no llega ningun tipo de señal a la pantalla. The fact is that once mounted the turn and starts perfectly but does not reach any kind of signal to the screen. He probado con otra grafica y tampoco y ambas me funcionan en el equipo viejo, al igual que la fuente. I tried with another graphic, and both me and not run in your old equipment, as well as the source. Asi que no se si son los puertos de la placa o que( he probado todos) o el proce (si fuera este llegaria señal igual a la pantalla, el problema seria otro no?) So if you are not ports of the plate or that (I tested all) or the process (if this would signal equal to the screen, otherwise the problem would not?)

Pues eso, a ver si alguien tiene alguna idea... Well, to see if anyone has any idea ... lo malo es que la placa la compre hace cosa de mas de un mes y no se si se podra cambiar o que, aunque supongo que si el problema es de fabricacion lo cubrira la garantia de Gigabyte. the bad news is that the compression plate does something more than a month and if you can not change or that, but I suppose that if the problem is the manufacturer's warranty will cover rioja Gigabyte.
=

2've connected the 6 pin connectors to the graphics? y el conector a la placa desde la fuente me imagino q seran de 24 pines tb no? and the connector to the plate from the source I guess will be 24-pin q tb no? sino es asi podrian ir por ahi los tiros. but so could go there for shots.

Yes, obviously connected. Repito que el problema es que no llega señal a la pantalla y utilizo todo y conecto de igual forma los mismos cables y demas tanto en una placa como en otra. I repeat that the problem is that no signal reaches the screen and use all the same way and connect the same cables and so on as a board in another.

the problem is that the board has all the numbers, but before the test to make sure RAM modules one by one is not any this bad.

I tried that too. En cualquier caso digo yo que algo se deberia ver en la pantalla nop? In any case I say something you should see on the screen nop?