Thread: The problem with the motherboard

System:
Motherboard: Elite group p4m890t-m
Percent: Intel Celeron D 366
Hard drives (2) Seagate ST3160815A - working and ST3160215A - problem
The problem is the following: when you connect a hard (i.e., when the drive is connected 2) The system can not boot: appears on a black screen error Primary Master Hard Disk Error - Press F1 to Resume. BUT in BIOS, all exhibited normal: boot priority - from the hard drive with a hard - to the fact that system. I do not know that already and I think the problem might be?

IDE hard should connect a wide plume must be hard to correct jumper at two ends of the plume, one of the other mother on the first hard to master, in the middle of slafe so hard on that in the middle need to move the jumper from master to slave . jumpers are located midway between the power connector and 40 pin IDE .