Thread: PC goes turn off after a few seconds.

Hi everyone,

Here I will explain my problem

I'm cleaning the inside of my PC, I blew air from my compressor because I did not bomb dry air on hand, in short I removed a lot of dust .

I also removed the CPU fan to remove dust and I also remove the processor, after all delivered properly (CPU FAN and CPU) I supply power to the PC and I start it and then I time to read "New CPU installed please enter setup to configure your system" then the PC goes off after a few seconds.

Why I have this message that appears on the screen? Is having to disconnect the CPU and then having to reconnect? And why my computer turns off all alone? I have this problem since I dusted inside and since I was kidnapped and handed over the CPU FAN and CPU.

Someone ever had this problem?

Thank you for your help.

hello!

The problem raise because of the faulty installation. when you back up the process, did you put the thermal paste? Look no further, the method is safe because it is too hot. Cleaned the old paste (with cotton or acetone solvent), and put in the fresh.