Thread: Brand new PC freezes always, Windows will not install

First what you want with nero Windows 7 32-bit and 8GB Ram, the combination really makes no real sense, second there are quite a few options in question, the first would be a bad CPU cooler attached angled or CPU fan not running then, thermal problems have such an effect.


Here you could just go into the bios and times as in the Healthcare Settings or something similar, if there are more than a short time after 50 degrees, then by all means check the CPU cooler times next, the Ram could run unstable, turn on time because the ganged mode to - and the Command Rate to 2T, also important are voltage and clock speeds of the memory.

Hello, it can of course be due to so many things, but one by one, i would first check the settings in the bios and "disarm" as the timings of RAM if you have not done, here especially the "Command-T T1 or T2. falls Vorhanden the temperature should agree, maybe even sometimes with only one RAM module slot to another try, and also check everything again tightened.

I use the graphics chip on board, i have taken out a memory and replaced, it ran better, I could install Windows, but it still crashes freezes, black screen or gray screen, the fan seems to work and can cool the processor, what can I do about it yet, am at my wits end?

Once you have tried everything now seems really, really well, it seems to lie on the motherboard - even if it allegedly tested otherwise, try again from scratch, and systematically first CPU - VCore control, not that this is wrong, second Ram - just a pure bar - enter Command Rate manually to 2 points, 1.5 volts.