Thread: Direct about the Phenom II

we will consider a bit more UN-conventional way to introducing few knowledge nearly the Phenom II performance. new growths in the overclocking and benchmarking world have formerly again jumped AMD into the limelight with their Phenom II set up slated f. information from AMD at new technology demos has shown that the dreadful cold swarm was all but gone allowing process at liquid nitrogen temperatures of -196C, and possibly outside. It was this knowledge that

nowadays we are purely going to concentrate on overclocking the AMD Phenom II with three very dissimilar mediums. The early of which will be with tradition close air cooling using an industry standard heat sink. This cooling moderate will allow full stable effects as well as the sheer maximum we can force out of the system without acquiring too insane with the volts.

With these effects we will assure what the Phenom II will be able of in fairly much anyone's hands. The following two cooling methods will just be for those that are into benchmarking and leaving to go sub-zero or, sub-ambient with temperatures.

The following traditional position in cooling is with water but we will skip over this option and jump directly to a Canadian winter by intends of a custom individual level phase variety cooler. The phase change we utilize will not a many different than that of an Asterisk VapoChill or Mach II GT unit that can be purchased retail.

This install furnishes temperatures as cold but will warm up considerably below load. From there we will assume affairs as cold as the processor can treat with total on liquid nitrogen cooling. this performing of cooling furnishes us with the power to get temps down to -196C if the processor or motherboard can handle it.