Thread: Create problem of Cable not connected

I acquired a new graphics card and i connect it into the pci-e slot it doesn't require power supply so i simply connected my video cable instantly to the gfx card and i turned it on.

The CPU vents the gfx card vents and the PSU vents are working,theres a green little light on the motherboard but there is no beeping sound. The Monitor says Cable not connected and nothing shows up nothing. I attempted resitting the battery trying the monitor and video cable on other pcs adding a little bit of thermal paste i nearly attempted everything i saw on Google and even nothing. Note that earlier

I wasted my former graphics card and before that i had the computer running very well for a whole year but i yet had a couple overheating problems.

I suggest you that what you mean by contributing more paste ? took out heat sink.

Contributing thermal uncleanness to the CPU.. like the small gray paste.

Did you clean off the former substance earlier adding a little more thermal grease? More is not inevitably better. A size of a grain of rice is adequate.

Also does your motherboard have integrated graphics? If thus attempt that one. I see its a P45 chip set thus likely not but worth mentioning.

No its not incorporated. i can simply plug it through the gfx card and yes i took out the former substance.

Bring computer apart admitting mono out of the case. Place mobo on a box. reset the CMOS by bringing out the battery for 15-20 mins. If your instructions proposes another performing of resetting Cmos do that too. I know you have done this but do it again.

Plug in simply mobo, psu, cpu, one stick of ram, and gpu. attempt to start it that way. If it does not boot attempt another stick of ram. concern to mobo manual to make sure that the one stick of ram is in right slot.utilize a jumper on the power pins of the mobo to start it

You sure the cable is not simply kinda bound on the back of the computer case. what i mean is i have had lots times in the past the event will push or not permit the cable to sit right so you acquire the cable is not connected and it appears like the monitor does not work.

I inquire because i had this similar issue with my gt 240 simply because it's a small card and acquire pushed around.

This true its kinda small and acquires pushed across x Dyes this an significant point 5 more mins and ill build up everything together again then ill assure it out.

Questioning if your board is contributing adequate juice? can you attempt your former card outta of box.

Are you speaking about my former graphics card that exhausted?

Does your card accept 2 DVI outputs? Have you attempted both?

Assert able have a crouched pin on CPU getting the no video problem.