Senior Member
Problems after BIOS flash I got myself an AMD Phenom II X4 955 (AM3) gained so the flash on my Gigayte ga MA790FX DS5 I had to run the BIOS version F1 To version F8I lack of viable alternatives, I used the program "@ bios" from Gigabytes website after seemingly erfoglreichen update the bios I've reconfigured Windows to boot properly then I installed the new CPU. The attempt to start the PC, the graphics card fan started to rotate continuously at maximum speed, The screen stayed black, I think because no signal was received normally, turning the fan on Graka once fully and then goes down again a speaker for error codes I have not a new replacement of the processor has no effect, just as the short-circuiting the dell cmos jumper.
Senior Member
Just try to check all power supply plug. listen to beautiful then, as if the cpu möglicherwese get enough juice it should be night because your time trying to use ram one by one and test each module individually. Otherwise try it after the Exclusion process disconnect drives etc etc hope you have vga test test hardware at home what time you meld hardware you could exclude.
Senior Member
Problem has solved itself, only the 12V plug forgot xD thanks anyway schonmal But now there is still a problem, but here you'll find the thread in the CPU: Phenom II X4 955 - Only 2 cores detected would be nice if you could help me there too .
Posting Permissions
Reply With Quote
Copyright Techfuels
Bookmarks