Thread: Overclocking tops in the Latinoamerica

My processor is an AMD Barton 2600 + FSB 333MHz (effective) or the memories that I left running at 333, not 400 (my mother supports 400 and the memory too)

That said, I will overclock to reach 400?

1) Improve ventilation? The chassis has a fan in front and getting air from getting behind the height of the processor, with an air ... Would have to change the cooler the better one for AMD, or the heat sink?


2) My processor is at 47 º ... this in a small load, I leave with a clean 45 surely ... I think it would be best to try to see if a bank is the overclock with temperature and that does not?

3) could remove the cooler to the processor? Is he pulling a practical side to the air, might be better put that in another position to improve air circulation, do not say ...

4) You want to walk with you to overclock my geforce fx 5200 (now is a 5500 thank you) ...

The card has no cooler, has a heat sink on the GPU without further ado, the reports have no heat sink. Then the sink side is upside down, so I think the ATX. But I do not understand, was not the heat that rose? As you leave the heat for this? Has to go through the card!

I do not think it can overclocked so much, but you say that you hit some coolers with thermal paste (I have checked out some old ... some sources use these?). If they say it could remove the processor, we'll get to this board? If I had to put a fan on the board, as I wear?

If you want to apply OC better than ventilation, get cooler and prepare properly for any heater. The graphic solution will be difficult, since it is their time now and it will be difficult to find cooler. For the CPU coolers are very cheap today that you will in the world to do something to moderate. Put also a good thermal paste, and make sure that you have to create a good flow of air into the case ... either by putting the fans you have, adding some more, etc..

What I did with a Radeon 9600 from a friend that was taking away the cumbersome that comes on top of the chip and replace the thermal paste made a crust for a little mx2 the mine, and somewhat improved performance that brought cooler

Greetings!

What you can put a heat sink on the chip with a bit of thermal paste? I refer to the memory of the video card and ram work better? I have no way of knowing because my motherboard does not have temperature sensor. Can I use the sinks to sources, cutting or better buy a better copper or something?

For me the meaning of cool and command something air from below the video.

Think you are complicating the lives nomas.

if the memos are 400 and want to get to 400 that is not overclock!

if you have more than 400 if it is oc

400 if you do not need to put some dissipation for memos, if ocean the process if there is

I would say to apply some oc fsb and tests on whether the temperature rise much cooler to change the process

Hello.

Just buy a good cooler for the processor.

Greetings!

When I put heat sinks on the memory chips I was referring to the video board, which I plan to make oc. Serve, or you can put a cache of source to sink memories? Help? Is that I have no way of knowing whether or not is because I have no temp sensor on the video board. Nor will I realize if I do shit on the plate when the video overclocking.

As to what the oc the processor, I will try what you say this because I re well with tremendous fan drawing air from the side.