Thread: P3 450 MHz died

p3 450 MHz,
8gg disc, video 64megas t (k I gave)
ram pc 100 192 mb and a source of power 125w

I gave it to my pc fan n k a target air front. the case was made that cut when you connect the cable to Molex reaches court did I was peeling and there was all this new circuit court caused a guess ... Sparks left and enter the process with the board .. But which would not change the load pa k parts is old, but reviving.
Ah at least when it began to review the source note shit sounded like loose screws or broken fuses. And if someone is granted k offers help send a mp pa k me in solidarity.

Thought pot was worse scrap andante xD

Intel Celeron 667 MHz
4mb Integrated video
64MB +256 MB ram
14gb HDD

In my house I have a Celeron 333 running even ... use current discovery is to see kids, online games and some other Leser you see my nephew of 5 years xD

sorry about your Pc, my condolences to the family.

Pure sympathy but no answers so far ...

You can try the source alone, unplugged everything (if it is ATX source) with a standard power cord plug 12v q minimum support side on a green wire and any black (if switch) tour and see if the fan does not rotate or if the fan is bad or the source, and there is more stick hand.

Process, board, memory cards and q are tested in another pc, yes or yes, the problem is q if you tell me died with scandal, better do so with care party could have been corrupt and can be made to lose the other pieces.