Thread: Voltage X2 5600 +

OCEA long this process will not have to raise the Vcore to keep it very stable.

Voltage at 5600 and I got 1.40 @ 3.22 MHz and the plate is 1.50.

It may raise the chipset voltage a little to lower the Vcore the procedure?

Not so much overclock ... find out if the overdrive can download a little...

I have a 5000 + 2600 MHz @ 2990 MHz 1.35 volt 1.30 volt!

I use the ODA so that you can also find out if the lower voltage.

If it is low voltage but a step 0025 v giving me the bios of the board sends me the error.

I get to 3500 but am hardly even the 3400 how can I know the 780g chipset voltage?

Funny, a friend of mine has a 5600 + and took him without touching voltages, just download a 236x14 ht, 3300mhz, not because I went over the reports on the 950MHz and not down: P lucky newbie will I tell myself.

Weird though that I can upload more clear but unstable plate problem I do not think it.

Neither the memos nor are down to 667 to 357 MHz.

I did not.

Why each is a micro world apart!

Not you think so far for 1456 volt 3200 MHz?

In your first post said that I had a 1.4 volt, you got much uploaded or voltage?

If it was up slightly to gain stability is = I liked the at 40 min if I'm trying to give more performance and lower the frequency of memos from the top 400 instead of 667 are now at about 856 will be carrying either the patriot so far suggest.

I think the difference is almost nothing, but what if you are trying to do is overclock a more balanced frequency / voltage ... you can try as much as 1.35 volt to stable, but try and climb through the overdrive can always get more stable frequencies if you put him from BIOS.

This setup is good! likely now that if you can lower the frequency timings (how much voltage are now?) if you want to try putting the link in multi ht 5x, I doubt you of instability problems, but you can try!, I now got it in 1140 MHz (absolutely stable, after the nap I try to leave it at 1150mhz) until 1200 MHz the draft.

I hurry to get to 1000 so that it no longer so, the timing of the memos are from the corsair and patriot but not if you let them down if you probably would not give in to 4 or so instability and the Vcore is 2.25 to 0.05 (2.2 default) found that the process, it rose by little more and sends me blue screen ... 1 pt you upload and Vcore the part but falls ... will upload more and 1 pt alright ... sera ... I was dancing with the ugly now at least is a far greater overall performance than before.

Thanks everyone for the advice and tips.