OC on E2140 Dual Core

**Roger Arundel** · 05-02-2009, 11:50 AM

I need this process q to run but I run 1.6 to 1.2. Leave at about 2.0?

The model of the motherboard is ECS MCP73VT-PM

Hope can help!

Greetings!

**John Fanwryghte** · 05-02-2009, 11:51 AM

If the processor is well… the bad news is that this plates and if you can do by oc bios.

Go to the bios and see if there are options for changing FSB... or if the board allows for 1066FSB processors

Greetings.

**Roger Arundel** · 05-02-2009, 11:52 AM

In the bios there is nothing to change fsb ... I was told that updating the bios to the latest version can do it...

**Cael Anglian** · 05-02-2009, 11:54 AM

Bios usually have these plates do not give you any option. And update them on the website of the same serious.

You could find out whether this board is a clone of any q in the website and also verify that they are to put the bios.

**Chaddesley Corbett** · 05-02-2009, 11:55 AM

well, in that case I think the 1.2 GHz you see is the processor speed when idle (to use less energy) and speeds up to 1.6 GHz automatically when you load a little ... for example, gets a ride Super Pi while monitoring the frequency with cpu-z ... you should be able to see that there is a 1.6 GHz when required.

**Cade Hugue** · 05-02-2009, 11:57 AM

These branded PCs do not think that can OC ... They do this purposely so that you can not damage the equipment and then claim warranty (usually because no one leaves OC).

Anyway, you can find drivers and BIOS on the website of PB