Thread: Overclocking Amd Athlon 64x2 4200

I have made many possible configurations (x2/x3/x8/x8.5 LTD) and is the best work for me, in terms of frequency dividers is not only I get 3 options 400/533/800 and later lactations still I do not understand how to encode if anyone can explain, as I appreciate it, if some parameter settings are where I have exceeded example voltage or reports please!

Thank you very much to all!

I said in another post, most schemes should not change the multiplier (CPU Clock Ratio), if it was in "Auto" Let there also achieve higher growth because the default CPU that should be 11x. Let the same thing so further questions if I was born, was raise the voltage? Do not be stabilized.


Greetings!

Thanks for responding, I think we could put this configuration:

LTT x4
Multi car or x11
so the 250 could be htt

But would be about 2750 MHz, think you hold the microphone in increasing voltage is correct, I had no instability

A greeting and thanks!

Of course that if it holds. I have a 4000 + and I climbed up to 2.8GHz stable, more people here who have achieved the 3GHz, so do not worry about your 4200 + is that being in the world to reach 2750.

Hello.

Then I recommend the super terms of voltage? And where I find the blessed memory dividers.

Dividers are not exactly, to increase the fsb up with both the frequency of the reports only have to lower it to 400MHz on the part of your bios says Memory Clock. The rest of the reports leave it in automatic.

If true, when I tried other multi x8.5 / I x3 the memory 400 and not rising much, tells me pass super, I think I've animated the truth is that it is very tempting to 2700 MHz, which penalty not have many people to get more information or proof x11 car does leave the other values as they are? And now you do not count?

Thank you for your input!

Try increasing the timings of the reports, apparently when he came down the frequency is too far down the timings. Are at 4 3 3 9, try leaving them in 4 4 4 12 so that no effort. Sometimes it may be that you generate instability and perhaps these will raise the voltage to the CPU pure.

Just please try and while not reaching very high temperatures do not worry nothing will explode...

Thank you very much for the speed in responding.

The truth is that he is right, is one of the sections that do not dominate finish where the low timings? I think we will have to be on this page of the bios, it appears in 533, but the configuration I have now, if I understand correctly the drop to 400 and what are the points that I have to change in bios.

The timings are the ones that are down, look, you have to put up DDR400 and below timings are tested with higher the DDR400 timings to put down and that alone can be very demanding and you generate instability.

The other leaves as they are in order. And the FSB should be able to upload more; I got it stable at 260 with ventilation Stock.

I have tested it, when you put the memory to 400, I DDRII manual TIMING items. I get the typical message that we must clear the bios, I have tested with different and even different LTT ht, but I get the same thing and I have to wipe the bios be anything happens?

Thank you very much!

Hi

I think that your OC is not for much limited by the Rams, considered by some change more often and stay with the largest fsb with stability can be.

Well the truth is that I think you're right, I will continue testing and to indicate what the results in the change of memory are and what I am proposing, but I also think that it might get better results with another plate, can you recommend any? And a memory to 800 MHz is not it?

Best regards and thanks for your help!