Thread: Help with OC

Hit a lot and looking to OC in the my plate set, the problem is that the board gives me no option to change the lactations of memos, let me just raise the Vcore to the memo and the multiplier of the memo I have 3 options (2.66 3.33 4.0) in terms of cpu, let me change the voltage, fsb and the multiplier (between 6 and 9) what caught my attention was that I did not get the memo at DRAM Frequency I do not know if it will be good or not.

I get the temperature around 20 degrees. But in speed fan and I get temp1 -55 were not referred to that.

Greetings

The Fan Speed pure lies saying in temperature (there are cases that read well).

The memos do not usually close to the oc, often putting in chipset the bios, and see latencies must disable the option by September latency SPD or similar.

check the options one by one that gives the board, then upgrade to the latest version and nothing, it appears nowhere in the memos.

But what does this well, or is it advisable to change anything?

I ran super pi to 4m and 8m and the temperatures do not exceed 30 degrees, so q is well that way, but with the OC, this change good or something better?

The oc's fine, 100% sure to be a correlation orthos for a few hours, if not working or fails, the oc is absolutely secure. In this step you see that the maximum temperature reached CPU.

Hi

I think there are some options in the MB Intelligent option and High Speed DRAM DLL Setting default is 1 in activating the 2 test.

Hi

The ideal is that if you overclock the processor has unlocked multiplier is leaving the highest possible FSB and forcing the least.