Thread: First Overclocking

OC quite stables (no crash or anything like that) Waiting for the source and the cooler to upload more, yet I like the focus on the theme of Oc memory, it is possible to stop these run faster.

I add data as it passes the Agency shows me a little higher temperature the everest and I also said that in line 12.

Greetings

If you do not think much to Everest, with the probabilistic, misread voltages, but it picks up hidden sensors were disabled. Maybe 3GHz, but it would be to limit temperature by the voltage that would be needed, a little more fight with latencies that certainly that 5 may be a 4.

Hi

I left memories in order, only the plate covered by raising the fsb fence

Greetings

Hi

I have a source of 300w e2180 with a fan and makes him deaf or 2700 without raising a volt.

I have not had time to finish up my pc, have the same motherboard (an ECS 650i) is good overclockers can get around the 3200 but I am going to 3000 to comply. but for that I need to re build my water cooling system but for now as cool bullet in the video because I like to use it without fan the plate gives rise to all voltages and reports on 667 or 800 is also good if you can leave the synchronous but not much more what is gained and lost with that stability.

I still have not got anything to hand; you just raised the bus 800 to 1100 and did not change anything else. with that I left in 2750 there are some that will have brought almost 3900mhz these cores, but given that e2160 and E2200 will be the multi-or who knows.

If you no longer all others, go to the bios menu put in "expert" leaves the default reports in coming here 667ddr (333) latencies do not touch or move anything at all only increases the processor bus 800 to 1000 and see that he is very well here in 2500 if you want to go up to 50 and give it a hair over voltage when no party to the previous low or adjust a little more voltage does not upload.

Hello

I thought so, because lowering the multi to 6 I got nothing not evens my ex 775i65g (1200 fsb with a Celeron 420)...

What I have 2.8 GHz, is quite stable and the temperatures have not risen nearly nothing, never higher than 60 º the process.

We try to make it 3.0 GHz; booted, but crashed in the first picture windows ... this is due to the lack of voltage? I think this is my limit Oc because as I said in another post I would not touch the voltages and I think that 2.8 Ghz is more than enough pa 'play.

Greetings and thanks to everyone (especially GoldenX) for helping me to maximize my jar, and that in this forum for consultation and a complete upgrade vga the pc without knowing anything about this, I learned a lot and they all again for sharing your knowledge, that there always people who likes to learn.

Greetings