Thread: Help with OC

Compares, he hit a lot and looking to OC on my plate set, the problem is that the board gives me no option to change the lactations of memos, let me just raise the Vcore to the memo and the multiplier of the memo I have 3 options (2.66 3.33 4.0)
in terms of cpu, let me change the voltage, fsb and the multiplier (between 6 and 9) what caught my attention was that I did not get the memo at DRAM Frequency i do not know if it will be good or not.

The other, in everest I get the temperature around 20 degrees. But in speed fan and I get temp1 -55 were not referred to that.

I attach picture to help me and guide me.

Greetings

The Fan Speed pure lies saying in temperature (there are cases that read well).

The memos do not usually close to the oc, often putting in chipset in the bios, and see latencies must disable the option by September latency SPD or similar.

Check the options one by one that gives the board, then upgrade to the latest version and nothing, it appears nowhere in the memos. But what does this well, or is it advisable to change anything?

I ran super pi to 4m and 8m and the temperatures do not exceed 30 degrees, so is well that way, but with the OC, this change good or something better?

The oc's fine, 100% sure to be a correlation orthos for a few hours, if not working or fails, the oc is absolutely secure. In this step you see that the maximum temperature reached CPU.

Lower the cpu to 1.33 and you get to the memory I started at 0.1 wind, but I threw blue screen, it increased the voltage to 1.37 and remained the same, increased the voltage to 1.39 and the memo to 0.2 and I am starting. Are running the program I see stability temperatures.

What I was worried that the cpu-z shows me no DRAM Frequency and do not know if this is good or bad.

I reboot, get the fsb to 300 and lower the cpu voltage to 1.36 and the memo to 0.1 now appears to be stable, and temperatures in a full 40th.

Which is better, to increase the cpu, fsb and raise the voltage or lower the multi and raise the fsb and raise voltage?

Reports only have the options to change the multiplier to 4.0 and 2.66 3.33.

Hi

I think there are some options in the MB Intelligent option and High Speed DRAM DLL Setting default is 1 in activating the 2 test.

I leave the fsb at 300 and 9.
I leave the voltages at 1.36
multiplier of 2.66 left in the memo
I leave the memory voltage at +0.1 v
voltage on fsb +0.1
option 2 and let me what you say?

Hello

The ideal is that if you overclock the processor has unlocked multiplier is leaving the highest possible FSB and forcing the least.

Let me play here between 6 and 9, the multiplier of the CPU. That option 2 you told me that was in the bios effectively, but to serve? Marrow is gained by that?

The other apparently now becomes stable.

Hi

That option so I could see in the manual of the board is that these options should have a default configuration of the memory timing (latency) and have 2 options assume that the turbo that should tell you to adjust the memory latency .