Thread: Duda Overclock

I was playing with my 3600 and it managed to leave 2761 MHz fully stable.....

The thing is I was tired while playing with the memos and the only way was to leave at 533 @ 690.... Now the question.... the memos are DDR2 800 so.... there is no way to put it in the DDR2 800 overclocked the CPU?

Hi

Check if your bios allow you to change the divisor, or seven if the memos on 667MHz, so 862 would be in if I am not mistaken, I guess it should be able relaxing latencies endure.

Hello

There would have to come up some latency manually? Is that this board is half... or do any automatic or manual everything ... then would have to rise and leave latencies in 667 to reach 890 true? Because when I went but he was not starting the fsb Windows ... I just reset…

Hello

Latency is not the same as the frequency of reports often leaves the 667 and rises to its peak latency, which should go for 5-5-5-15. Not if you notice them, if you did not recommend that you do it.

Hi

I say this only because of my old manual plate 939 should only play with the fsb and multi another item latency of the snapping plate....

Hello

65 º is perhaps a little high, you can do is to download either clean, or put a fan or cold air getting into pulling hot air. Anyway it is not abnormal, and if you are stable, you have a nice oc.