Thread: Overclocking E4500

Overclock my jar I recently purchased
E4500 Core 2 Duo 2.2GHz, 2MB cache, 800 fsb
ConRoe1333 - D667 chip 945gc
Geforce 8600 gt 512mb
160 gb 7200rpm
2gb ram 667MHz
for the CPU fan and one side seems to PCI-express let me do the bios overclock since it has to do so in a way which I can raise the plate 200mhz bus and 100MHz rose to 236mhz bus to reach a frequency of 2600 (+ -)

Restart the PC and I ran over, I delete that file system to format it and tube reinstalled once a part of my hard drive apparently was damaged, because when it comes to a specific folder I drop the explorer.

What I want to know is if the hard disk onto common or not? And how it will benefit not only the extra heat sinks manufacturing and protections that I take. And I did in my previous bad experience.

The idea is that mine is a 2600 that is my goal.

Greetings

Hello

It is rare that the disk failure so, for me the problem did not happen that way.

Give a Scan Disk to see if it fixes anything.

Hi

I know that should not have died from the hard drive, if you suddenly that the system is corrupt, but that did not review it.

Greetings

I think the problem was yours to have acquired a low-end motherboard, this board is not very good to say, and I had an experience similar to that a little bit lower and the time he gave no problems and video.

In any case did not die at all, is only part of the critical errors such as falls the "Explorer" I understand ... By the achievement to get some more.

This time it raised more bus 5 hertz to 209 and my processor runs at 2300 MHz running consistently well-lamp.

Consultation in all cases was that safeguards should I take if I want to OC to 2600 (is my goal). If you just mention that the fans need to install or anything else relevant configurations do.

Greetings