Thread: Overclocking E8400

Hello

Is my first interaction with the processor and no more or less up soon can I increase the fsb of the reports are about 2x1 GB PC 6400 the HP, with a blue heat sink.

Thanks in advance.

Not bad, I hope this 100% stable ... check my topic; I like you, same process, same type of memos, almost the same result...

I actually run 2m and to see how he did it in 28.891sa 4 GHz...

What I need now is more memos, which I limit...

After a while the first run I shot an error, followed by tests but there is stable.

Sets with heavy as Crysis, Lost Planet, Lineage 2 (4 accounts) and will not shut up or step 50 °. Also published a couple of videos and nothing.

Only the error in a first core 95, will be flat for Vcore? Indeed the reports are 4-5-4-11 at 850 MHz as 2.1vy approx; can climb in voltage and fsb?

Thanks in advance.

3dmark01 measured much the platform, not just video ... So is not the same effect in games ... comparing an E8400 with a 3200? I also had this process, the truth and the difference is huge ... that achieves the maximum for that, with memos GAMER OCZ PC3500 UTT chip was 7000mb reading memos, and I'm going with this in 9000 and it is not an end or the maximum overclock I can achieve, I will buy pc8500 memos now a story and you will spend 10k on everest ... the only test of memory might be slower, is the latency ... surrounding the 40-60ns, I could 25ns another platform ... = even but the difference is huge ...

Further, the other was built in 90nm, 45nm in this ... or in space using, quota this beast...

I'm stable and I shot a first mistake, I had the same total game when nothing happens ... and if other people are using MSN, So I have no problems in being somewhat unstable.

If you have good cooling you will have no problem ... and if your board allows even better ... 2.35 if you can not get to 1000Mhz, but at least you can try removing 4-4-4-15 ... but surely pass the 900MHz with timings at 2.2v those.

Let you see what the other as 920 MHz, 4-5-4-11 at 2.1v. I will try to see me until remains stable, is not a bad pass 1000 MHz? Or when the voltage is below 2.3v? Without touching the Vcore much I do not think I came out a bad batch, all this I put on the plate 1.3125 Volt and the cpu-z mark me as v. 1.2 what is the real value?

Greetings

The bios is real good source? Or generic? 1.3125 is still in the process of VID, so you have no problem.

Attempts to increase the process more, something closer to the memos 1000 MHz ... with these other 2.2v, but raises the CAS…