Thread: I have an overclock problem

I have an AMD Sempron 3000 + working 1.8 know if the actual speed where to change the fsb in my bios will not let, is my k8 MMV and so I think the ram work is slow and well just buy a separate video card asus gf6200 and my pc was slow to install the Windows Start of my memories and my processor overclocking gods

Thanks

Welcome friend to this community, I hope you like it is here to share with us as we are with you, I hope you can stay with us, regarding your query processor goes to the actual speed, but your memory, you must manually configure the frequency of memory from the BIOS Features Advanced Chipset and DDR Clock / Drive Control.

You have to leave the memories running at 200mhz or 400DDR (which is the same) are running at 100MHz which is half what it should.

I do not know the board, but you should say or give a 200mhz FSB reports dividers 1 / 1 1 / 2, etc ... if so you have to leave it in a division that you 1 the other, that you had before vga ... integrity? Formatted or install the new drivers for your vga over windows only?

If you take more in the bar normal load is now being recognized another device ... if much, its recommended format.

Welcome to World overclockers!

I have this board but is lacking K8 MM3-V 3 and if the process is running which corresponds to the memos, but not reach 400 ddr 400 obvio@2.5 3 3 12 I have I but that depends on the brand.