Thread: How do I overclock my PC?

That will give you the specifications of my PC ... There is something strange try playing Call of Juarez and I ran a little wrong and take longer to load q Fuck a scene .. Probe the Dark Messiah of Might and Magic, and it took so long to load and could play around by half in graphics... Call of Duty 2 I get 30 FPS with everything at maximum, should do to give me 90 more or less? I have a ...


64 Bit Athlon 3000 +
200GB SATA
1GB RAM (2x512MB Dual Channel Using)
PNY GeForce 7900GS

Thank you!

What can you do? Well Overclock!

Loads of games will take you far, especially in the call of juarez, because these calls a lot of RAM and in the limit of CPU requirement. Begin to increase the FSB in the bios and look for a 5 Test setup and is stable. And of course there is more to force the FPS VGA. I have read out there that the 7900gs is well overclockers. I remember looking at the frequencies that will reach the core memory or they may in the process of finding the maximum artifacts of the VGA (display errors) (if it would stop artifacts, although I think the program does only) or PC crash, so you'll know which frequencies are hang up and reset some of the low frequency limit and that figure are consistent with an average temperature acceptable. To test the stability of the new configuration of the VGA chooses "Scan for Artifacts" (choose your time - if my 5 minutes not artifacts me this well). If you artifacts or high temperature is very low frequencies and try again.

In any case, a better result for the model tries to find out your motherboard and ram.

So you can see the ram latencies of the memories, which I personally have given me many extra FPS.

Board = Phoenix Technologies, NVIDIA 410/430 MCP chipset, Sensor ITE 8716 = rams 512mb PC2-4300 (266mhz) Silicon Technologies Proc = Athlon 64 3000 + Orleans, multiplier x9.0

When I try to use ATI Tray Tools tells me I have no board or Ati Catalyst drivers...

Buddy you do not OC the video card but the default procedure that card gives you a good 100fps process tries to get around 2.4 or 2.3ghz to your process and see that you were to raise the FPS card.

Is not limiting if you have a good setup at the top of the clock vga, enhances performance in FPS, but you have to climb watches memory and play with the configuration of the filters of vga! with So to better the quality of the game, now here is the processor speed that is 3000, resulting in a bottleneck for your Overclocked processor is more or less simple if you drive in the topic fsb climb, lower the multiplier if performance or leave the multi MHz intact if you want more, lower the HTT multiplier ax3, raise the Vcore to overclock that according, you can now leave the overclock on the memory synchronous or asynchronous , depending on how much your memories Hold on.

If you have a good cooling do you recommend others to get OC about 2400 if you have good ventilation lowers the HTT multi to 4 if the memos are not 533 leave 333 (166) option if you are leaves the frequency process in the 240 and the Vcore that if you have the option of 1.4 to 1.45 if you based this test well in temperatures if gives you the option of uploading the Vcore goes super. Throw it around to see that such an IP.