Thread: AMD Athlon 3700+ overclocking

Hello

I buy a 3700 + and I know how to find this oc. By the time I got to 2600 because of t °, 3000mhz but as you get warmed too much, I leave here is good:

overclock
Vcore: 1.6.
VDIMM: 2.9
frequencies of memos: DDR400.
Fsb: 237.
3-3-3-8 latencies.

Consultation, it is the first time that an A64, not Vcore to go well with these guys, I tell you.

Greetings.

I with the same cpu, and left at 2800 with 1425 volt, 2600 with a 1.35 volt, test ..

When I gave him a lot at low speeds Vcore…

The ventilation box, you get 2800 stable and not moving from the 50th to full load...

Checked = CETE of the memos. For stability...

I miss everything, but does not pass insist drama is stability memos are not the same and do not work well together, the Vcore down to 1.45 insist it is not stable and cooperate so is not shit to do.

I will again leave the default to see a memo on happens if I do that.

Greetings.

Test with one memory; that goes best of both!

Therefore have the Vcore too high for low OC!

Seriously the fan and you should dispel better.

Greetings.

That is super on, depends on stepping, there are processors that are 3.000mhz to 1.4v, others do not tolerate that speed with respect to the memos, if you hold asynchronous processes with respect to a 200mhz should not lose stability, I think it's just that your process is not over, or your plate becomes unstable to both fsb, in short, are a thousand factors those affecting the potential for overclock.

I recommend not to change your voltage, low on your DDR333 ram, and maybe upload your FSB lower your HT, as they do not want your 1000Mhz HT above this, I OEEC my cpu to 2.4ghz and lower the ram to DDR333 and I run DDR400 2-2-2-5, my HT is running at 960 mhz I think and my cpu to 2.4ghz, with no increase in temperature, use CPUz to verify your HT is not above 1000Mhz.

Must have some other problem, because it can not be left unsettled to 2600 with 1.45, that you should give the 2600 a 1.4, you must have some other problem...

The other thing that came to mention the 3000? Not have any capture caches....

If I said that the problem here are the memos, the ht this post in less than 800 if not 1000, if ever the drama are the chips of the memos, I tried everything but can not overcome a hardware problem such as more of these reports, so it ceases to run at 2.6 with Vcore 1.5 only, but this half = unstable in relation to the calculations that super, that I began to play cod2 and all day and not be dropped never.

With respect to the chilled cabbage, the fan never funk very well say no to either remove the heat so I'm going to change an entire copper.

Greetings and thanks for the comments.