Home Register Members List Search Today's Posts Mark Forums Read

Go Back   TechFuels Forum > Hardware > Overclocking

Reply
 
LinkBack Thread Tools
Gabriel Carlos
Member
 

Gabriel Carlos is offline  
Old 06-09-2009, 09:49 AM
  #1 (permalink)
AMD Athlon 3700+ overclocking

Hello

I buy a 3700 + and I know how to find this oc. By the time I got to 2600 because of t °, 3000mhz but as you get warmed too much, I leave here is good:

overclock
Vcore: 1.6.
VDIMM: 2.9
frequencies of memos: DDR400.
Fsb: 237.
3-3-3-8 latencies.

Consultation, it is the first time that an A64, not Vcore to go well with these guys, I tell you.

Greetings.
Digg this Post!Add Post to del.icio.usBookmark Post in TechnoratiFurl this Post!
Reply With Quote
Alexavier Nash
Member
 

Alexavier Nash is offline  
Old 06-09-2009, 09:50 AM
  #2 (permalink)
I with the same cpu, and left at 2800 with 1425 volt, 2600 with a 1.35 volt, test ..

When I gave him a lot at low speeds Vcore…

The ventilation box, you get 2800 stable and not moving from the 50th to full load...

Checked = CETE of the memos. For stability...
Digg this Post!Add Post to del.icio.usBookmark Post in TechnoratiFurl this Post!
Reply With Quote
Gabriel Carlos
Member
 

Gabriel Carlos is offline  
Old 06-09-2009, 09:51 AM
  #3 (permalink)
I miss everything, but does not pass insist drama is stability memos are not the same and do not work well together, the Vcore down to 1.45 insist it is not stable and cooperate so is not shit to do.

I will again leave the default to see a memo on happens if I do that.

Greetings.
Digg this Post!Add Post to del.icio.usBookmark Post in TechnoratiFurl this Post!
Reply With Quote
Francis Ronaldo
Member
 

Francis Ronaldo is offline  
Old 06-09-2009, 09:52 AM
  #4 (permalink)
Test with one memory; that goes best of both!

Therefore have the Vcore too high for low OC!

Seriously the fan and you should dispel better.

Greetings.
Digg this Post!Add Post to del.icio.usBookmark Post in TechnoratiFurl this Post!
Reply With Quote
Fidel Fleming
Member
 

Fidel Fleming is offline  
Old 06-09-2009, 09:57 AM
  #5 (permalink)
That is super on, depends on stepping, there are processors that are 3.000mhz to 1.4v, others do not tolerate that speed with respect to the memos, if you hold asynchronous processes with respect to a 200mhz should not lose stability, I think it's just that your process is not over, or your plate becomes unstable to both fsb, in short, are a thousand factors those affecting the potential for overclock.
Digg this Post!Add Post to del.icio.usBookmark Post in TechnoratiFurl this Post!
Reply With Quote
Erick waugh
Member
 

Erick waugh is offline  
Old 06-09-2009, 09:58 AM
  #6 (permalink)
I recommend not to change your voltage, low on your DDR333 ram, and maybe upload your FSB lower your HT, as they do not want your 1000Mhz HT above this, I OEEC my cpu to 2.4ghz and lower the ram to DDR333 and I run DDR400 2-2-2-5, my HT is running at 960 mhz I think and my cpu to 2.4ghz, with no increase in temperature, use CPUz to verify your HT is not above 1000Mhz.
Digg this Post!Add Post to del.icio.usBookmark Post in TechnoratiFurl this Post!
Reply With Quote
Emanuel George
Member
 

Emanuel George is offline  
Old 06-09-2009, 09:59 AM
  #7 (permalink)
Must have some other problem, because it can not be left unsettled to 2600 with 1.45, that you should give the 2600 a 1.4, you must have some other problem...

The other thing that came to mention the 3000? Not have any capture caches....
Digg this Post!Add Post to del.icio.usBookmark Post in TechnoratiFurl this Post!
Reply With Quote
Gabriel Carlos
Member
 

Gabriel Carlos is offline  
Old 06-09-2009, 10:00 AM
  #8 (permalink)
If I said that the problem here are the memos, the ht this post in less than 800 if not 1000, if ever the drama are the chips of the memos, I tried everything but can not overcome a hardware problem such as more of these reports, so it ceases to run at 2.6 with Vcore 1.5 only, but this half = unstable in relation to the calculations that super, that I began to play cod2 and all day and not be dropped never.

With respect to the chilled cabbage, the fan never funk very well say no to either remove the heat so I'm going to change an entire copper.

Greetings and thanks for the comments.
Digg this Post!Add Post to del.icio.usBookmark Post in TechnoratiFurl this Post!
Reply With Quote
Reply


Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
AMD Athlon 64 3500 + overclocking Caiden Bracken Overclocking 3 06-05-2009 01:33 PM
Overclocking the Athlon XP processor Dominik Macullam Overclocking 4 05-19-2009 12:27 PM
AMD Athlon 3700+ (ADA3700CFBOX) woaya Processors 0 07-02-2008 12:43 PM
AMD Athlon 3700+ (ADA3700BOX) woaya Processors 0 07-02-2008 12:35 PM
AMD Athlon 3700+ (ADA3700BNBOX) woaya Processors 0 07-02-2008 12:32 PM


All times are GMT +1. The time now is 08:02 AM.

Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2010, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.3.0
Copyright Techfuels -->
SEO by SubmitEdge


1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151