Thread: Need overclocking guides

Hello friends

My memories believe that if under the CAS to 2.5 and I run a little better OC? I recommend?

Or that I'm right? (Although I would love to reach even more OC)

Help will be appreciated!

Thanks in advance.

Try to lower the latencies, you lose nothing. And another, give up the fsb a bit more, but that gives other more.

I recommend that to improve, optimize your windows, would be nice to disable the ornaments windows (system> advanced> look), also disable the System Restore.

If you try to reduce latencies and that value is not so much voltage they can give, by default come with latencies 2, 5-4-4-8 to 200FSB and 285FSB currently have on.... nose both latencies can be reduced to ... is the voltage? I think stand up to 2.8v ... I did not raise me to play more....

Note that the higher speed memory latencies also climb ... if the upload speed of Memory’s and low latencies, it is very likely that the PC is re-started after a short while of being in Windows.

I think I leave the configuration as it is autonomous, and leave in the day, like full-day running prime95 torture test with.... provided that detects instability, has suddenly running hours be throwing a warning, but I detected something or 8 megs is detected ...
prime95 applies, and if he manages to spend about 5 or 6 hours, you might try is to tighten the latencies.

Greetings

Leave the memories from the bios to 133 as a 200 or a little less ... and latency, the marrow upload ... should stop as the walk down to 200mhz and then run it on prime95 for dismiss the reports or if the processor is the instability.