Thread: AMD 64 Venice 939 overclock

Hi

I have a problem on AMD 64 Venice 939, an + ultra 9npa epoxy plate, disk Hitachi SATA2 82gb, EVGA 6800gs 256bits, 512 ram (Kingston, Mark Vision 266) -> did not reach the money: a source of 400.

Not right in the games ... I tested with new drivers, but in Enemy Territory are closed in parts as 120 fps with open sides but few details down to 20, 30, 40 and not go up .. Maybe you can be the bios settings or anything ... waits for help.

Put another to release the source and purity of 400w.

400w with the source of the mother and pick up just what it means and the remainder with other sure there are a by a 350W or 300W pc oldest.

Good choice ... give me buy the 500 with the source of PFC is not bad ... but is equally here have another source 350 by turning ... I do like to be running the 2 ... to let the motherboard and the vga to the source 400 and the hard disk reader with 350?

A normal way to the source and the other doing a bridge with a pin clip on the unarmed green (is the only one) and one black.... And walk ... I was bored of the system each time off the jar had to cut the switch to another source and then turn on the switch when I turned the jar, and q is always walking.

Your memories are of 133?

If thus, you have a bottleneck in your memos and FSB micro miss you a Yield-Optimal default (optimum around 200 or DDR400 is the same).

From the source, is to suggest a suitable substitute to consumption and presence of your hardware.