Thread: Phenoms II X2 550 turns into a Phenom II X4 B50

I got a phenom 550, a gigabyte 770T UD3P mobo, DDR3 1333Mhz memory chip, and a Sapphire ATI Radeon hard disk 4850 display card for my unique put up. Having read about the frequent success of unlocking cores, I actually required doing it. But I had fears of contravention the CPU or motherboard, yet I still did it the same day I built the PC.

I restructured the bios to the new edition, went into the MB Intelligent Tweaker in the bios distorted EC Firmware Selection to hybrid, and set the ACC to auto. Then I save the settings and exited. A message flashed that said "UPDATING EC FIRMWARE, DON'T TURN OFF OR RESET SYSTEM!" Then the computer turned off and after about 5 seconds turned back on.

Both Windows are said to be that the computer was a new skill develop programmer, and so did any other program or utility like CPU Windows provide it achieve and as a dual core it was, I ran the latest versions and it gave the computer a get score card.

But be confident to get a first-class cooler if you map on over clocking it. As a dual core give it a score a lower. So when all 4 cores where unlocked it was operational almost two times as good. It was Prime95 Stable and over clocking this object was a gentle wind because it's a black version and has an unlocked Multiplier.

Conclusion:

I buy this computer chip for reasonable cost, but the presentation I got in the end was worth way more than that. I mostly got a phenom II quad core black publication! For the price this is the top CPU you can get!

Where do you get the consignment number? If it's on the computer chip itself, then I don't identify since I didn't read what was on it. Plus it's before now install. Maybe when I'm going to acquire a new cooler I'll check and if you will still be concerned I'll job it awake.

Nice I’ll tries it, pressure analysis it, and standard it. Then I'll post up what I got Still, Does anyone have a score for a stock speed? I would actually appreciate it and thanks I was fortunate my gaming rig booted on the first try so far so first-class, except for an intermittent lock-up difficulty I am having, I'm trying to tweak my way out of this difficulty before I release all my cores.

I observe all well I got all cores not closed and I manage to over clock stable. My electrical energy was 1.4 I'm sure I can hit 3.6 and make it stable I hit 3.8 and it was stable sufficient to boot windows and run 3DMark06 benchmark the scores were incredible. I’ll post up a monitor shot afterward, I'm reinstalling window.