Thread: Trouble with cool - beginning PC

I have AMD Phenom 2 940be ,ASUS M4A79 Deluxe. ATI Sapphire HD 4870 512MB GDDR5,be rather Straight Power 550W. Have all the components are correctly set up. I turn on the PC and nothing ... . That means almost nothing ... motherboard arrive with power supply, central processing unit heatsink is warm, all the fans Go to hard disk as well. Graphics card with no signal, the typical 1x beep at the commencing of the boot process does not, there are no beeps from the CPU board, which would show any fault. And for the conclusion turns on the computer later about 10-15 min. Have the power supply and replaced the motherboard (same model) ... similar trouble.

It is too potential that your system is acquiring by it is POST early the drive have a opportunity to achieve operating velocity. If you are by passing the complete memory try, test enabling it to delay the CPU board hammering the hard drives so rapidly.

So the PC goes to the central processing unit heatsink is warm and all will jump in? I would create no such symptoms 10-15 min my computer start. Your megabyte has a VGA slot, there times that you test to acquire a signal, so at least you can might be see something?

Does it restart later a reset? Eg. from start key not a bios reset. Might be a slight voltage gain will assist.

It audio similar to you have an consequence that is being masked through the PC resetting it is maintain Alive storage. I bet there is a vacuum leak or same consequence causing your trouble. Zetec motors are notorious for PCV hose degradation and causing air leaks. I would begin there first, it is the simplest and cheapest route if you search a trouble.