Asrock Z68 Pro3 Gen3 possibility defective

**Janilla Donald** · 05-08-2012, 10:50 AM

I had recently ordered new parts here, and after assembling was now for an estimated 10 days all off almost without a hitch.
First, the relevant parts:
ASRock Z68 Pro3 Gen3
Intel 2500k (boxed, so used)
XFX nvidia 8800GT
BeQuiet 630W PSU
Corsair XMS 2x 4GB ram.

The problem looks like that previously I had to load a freeze after the restart and nothing was more, no beep (!) More, just no picture on the monitor. In the last two days it was in places to hangers, thinking that because the graphics card would be more smoked (some 110 degrees under load), but this does not seem to be the case.

**Hiram Amaral** · 05-08-2012, 10:50 AM

Have you tested your board over time, the onboard graphics connections the ram, if possible, test it on another board once or golden memory or memtest86 check.

**Dexter Jane** · 05-08-2012, 10:51 AM

Thank you seems to be like but more widespread problems with this board Well, then I'll probably me quickly define a new one, since there is probably more or less evident on the board.

**Dathan Torquato** · 05-08-2012, 10:51 AM

If it is generally looking at the board is not known. only with the Gen3 boards in general, it was not so full, you will first probably nothing left but to ram test positive, to send the board fortunately, the commendable support of ASR

**Emil Justa** · 05-08-2012, 10:52 AM

I understand I do not possible to test the RAM elsewhere , Since only a DDR2 board rumfliegt here The DVI connector on the board also fits strangely, not with my DVI ports, So I just hope that a new board brings improvement.