Thread: Doubts Overclock Athlon II X4 635

So roughly these values are well Take off the fear of touching the vcore and download it, that people of AMD is too generous to the voltages, think less anger as well and also will consume less heat and, try to leave at 1.35 v and gradually lowering it until he sees the minimum to be completely stable.

Thank you, is that being Linux newbiein this I'd rather go warily, hehe i have seen some people that theHT rises to about 2400. I have chosen to leave almost the same valuesas before, but if you go up the multi to 10 which is the maximum thatlets me, did note some improvement in performance with it, would havemore instability and at a voltage of 1.35 V at a low temperature?

Raise the HT gives a little more performance, so it's good to do, hehe and yes, of 1.40 V to 1.35 V is quite noticeable temperature difference, especially at full.

Thanks for the replies, i shall try toraise the NB to 2250Mhz, what a mess I take big issue with thevoltage. I say that I put 1.35v, but I get to the BIOS and disableauto voltage, I left all settings to manual and I get as Core is at1.35v, if I leave it and also I get a warning flashing that says"Voltage not optimized, so I put back in order.