unable to functioning exactly in multiple approach levels in HP Photosmart B110a cabl

**Kerstan Henry** · 11-23-2011, 12:17 PM

I am utilizing HP Photosmart B110a Wireless All-in-One Printer machine in my cybercafé. I have multiple wireless approach level approximately 15 PCs utilizing the similar SSID. However, while circumstances the setups of printer machine on the Touchsmart panel. It was demonstrating few fault, which I am not friendly with this fault. The mistake is “More than one access point/wireless router has been got that matches your network name (SSID).

**Joyce Antony** · 11-23-2011, 12:18 PM

I actually do not wish the trouble similar networking, because it has frustrates me. Ok then too, I am assuring you few results first, you clarify that 1 system from your Access levels that furnish the DHCP and the other system are in bridge mode. If entire the system have DHCP activate and only happen toward add the similar SSID, which is technically multiple networks and subnets

**Pepin Henry** · 11-23-2011, 12:19 PM

The form you are utilizing it is should function can you assure me which brand is the DHCP server you are utilizing and too assure me how the Airport express is configure are you utilizing Extend wireless network or other network

**Pepin Sidonia** · 11-23-2011, 12:20 PM

There must not be trouble while utilizing this form. I am too utilizing similar HP Photosmart B110a on an Airport network with 5-access point and they only hook up. Just I am suggesting you few solution test it.

**Angelo Prosper** · 11-23-2011, 12:21 PM

I observe my WLAN setup is well; I actually only need the printer to "connect" to the access level with the strongest signal, which is what I observe my computer is not. This will automatically lilnk when it begins and would not have happened manually to assure it to pay no attention to the situations of multiple access levels and just have to link anyway

**Gene Philip** · 11-23-2011, 12:23 PM

I am challenging interchangeable position described at start of the post. I have invented a workable program to design the printer through switching off entire Access Point's with the exception of one. Once each trace of the AP's is dynamic, accepting that I switch just and again the printer, the situation is revising. Thusly, I am constrained to maintain the printer ON each trace of the time