Problem with wifi printer

**Polidoro Rancul** · 06-14-2012, 11:13 AM

Hello, I recently had the task ofgetting my parents to buy a new printer, since we have severalcomputers on our network and have little room next to the router, itwas clear from the outset that there will be after the status of thisprinter is now connected, on the PC I could find the printer anywhereand therefore cannot install the software. After printing the networkinformation, I had the ip of the printer and I was able to installthe Brother software, only now the printer will be permanentlydisplayed as offline, the computer says that the printer is turnedoff, but this is not so, because it can be Unignore at all.

**Deodato Daryl** · 06-14-2012, 11:13 AM

This is of course not with the Router dollar so that can be, so that what has to be done, i would uninstall the software times from the PC, then install the printer via a USB first and configure - with my epson I could then select the device in spite USB Installation When installing, I would like to use the printer via Wi-Fi and the Wi-Fi data by USB to the printer. Take the best offer and software, the Brother on the website for the model, if you now only have the drivers used by CD, the CD is often updated.

**Joana Egia** · 06-14-2012, 11:15 AM

Yes, the problem is that you can not directly connect the printer via USB, although it has USB, but this is intended to USB sticks, or otherwise, man it can only connect via WiFi directly to the PC, but I do not want to. Now even my mother would bother to search out the data so that I can reset the router, will again tomorrow installieren the software and disconnect the printer to the router and hope it works then.

**Gartzen Egiarte** · 06-14-2012, 11:16 AM

Of course you can also connect via the USB, are you looking quick reference page 9, there is where you'll find the three possible types of connections, USB, LAN or WLAN, and USB is from page 10 The USB Port is tired of possible "hidden" inside the printer, the Brother is on so often, all you have to lift the scanner unit.

**pedro Anaia** · 06-14-2012, 11:16 AM

I am stupid hit head on table gesture, I've been surprised, of course you're right, the USB port is located internally and you have to lift the scanner unit, luckily I have you, otherwise I would already desperate. Tomorrow I will make myself ran again and see what comes, i manage over wifi still does not, but it works fine on the network via lan we let him now connected via LAN, thanks again for the help.