Thread: Case screws 7200.11

Died two HDD Seagate 7200.11 DiamondMax 1TB and 500GB, the latter was bought three weeks ago. Diagnosis - when booting BIOS lag 1-2 minutes, after which the disks are not detected. When the screws from the network, no lag. What should I do?

1000GB: ST31000340AS
500GB: STM3500320AS

At standing system, a lot of data. Survived - had decided to marry off (do not screw it and three months), but here's how it happened.

You can ask if I have the screws, for example, brought them to our support team?

There is a suspicion that the firmware update may not help, but in any case, contact with the discs under warranty.

The same picture, only the screw 1 TB Seagate Barracuda 7200.11 ST31000340AS. Only to copy it all information and after restarting the computer does not boot, missing screws SATA1 and SATA3. The method of exclusion found that it died this screw. Connect more than one; it in the BIOS is not even defined. I understand that, come the end of the controller, this firmware is unlikely to help. How much lead replacement controller? A woman is hard to explain that I have nothing to do with. Yes and I have a whole home film library.