Thread: problem with AVG video card.

Hi everyone!

I mention my problem to see if someone can help me. I have a PC with a Asrock motherboard K7S41GX that comes with integrated video card and got a ASUS Radeon 9200SE 128 MB AGP, so I started to install. I connected the plate and put the following in the BIOS:

In Advanced> Resource Configuration

Primary Graphics Adapter: AGP (formerly in CRP)
AGP Data Rate: Auto (on the motherboard says AGP 8X but the most you left me here was to 4X so I left it in AUTO)
AGP Fast Write: Enabled (I'm not sure so I left it as it was)

When you turn on the PC I found that there was never signal to the monitor (left with the little red light) ... I see nothing! The AGP's mother works because I connected another plate and took the plate smoothly and also because I tried it on another PC and walked ...

What can be wrong then? Any ideas?

Thanks in advance!

Thanks for the suggestions!
On the issue of voltage (I think the most likely to come from this side of the problem) I found out that the AGP slot is 1.5V mother ... actually had a sticker attached which read: "Please do NOT use a 3.3V AGP card on the AGP slot of this MB. It May cause permanent damage."

What is unclear is to determine the voltage required by the board ...I reset the BIOS I tried but I think I did wrong (I never did before.) In this mother rather than have a change of position jumper two pins I have no jumper and according to the manual I have to put a jumper there for 3 seconds ...

It's a silly question, but what I have to do with the PC off or put the jumper and light it for 3 seconds? How do I know if I could actually reset?