2000 pages of files windows swap file 95/98 windows of a department working in the file system and virtual memory to be used. It is important to note that a lot of RAM in your system, but you, you will always need the paging file. Unlike the file size windows 9x dynamic is not set: to see the size of the file system settings in the Control Panel to open. Advanced tab on the phone to locate here. Suit / performance options for the size of the paging file, which was natanaepni to configure the system. To change the settings, including the minimum and maximum values. Suit, and click Settings, and then restart it. It is wise to do so before running Defrag.

What is the size of this file is so right? Microsoft referral + 12mb Ram, at least that is, 268 megabytes RAM 256 MB system of the paging file. This is a full dump of the memory system, to allow the event to the accident. People are advised to use a 256 megabyte less than the value set slightly upward + 12mb RAM: 128 megabytes of memory or less, and they should try x 1.75, or 1.5 x 128 RAM, you must try. Remember, of course, there is no harm in the pages of the file to your advantage and superior value to the set, you just have to lose the disk! If you are tight on space, or at least equality, you must set your page RAM, which is less than a user's system can arise from the conflict. Some of you used to monitor the performance of the 2000 suit. Windows built to guide you.

To define maximum page file size can make. Do not worry about the maximum size of the page file. 2:58 doubling the size of the files by using the setting of the size of the homepage. 2000 is a dedicated file size of the windows of the page when you need to expand and to use valuable space on the hard drive, so if you do not need if you do not. This way, you avoid the suit. "Out of memory" errors during the complex operation.

Improve performance. Suit multiple physical disks, and the spread of the file into your page, do not worry about the speed of the hard drive mase yo windows automatically select the memory of 2000 is a one-page quick vehicle. To create a file of the page, not to be confused with the partition of the hard drive. You should write a page of the same file on the hard disk inside and multiple partitions. The set - significantly hampering system performance, because if the windows nt writing these pages to disk files to the hard disk is paleului forced to shake back and forth across the disk, rather than remain in the general area of the file to a single page anyway. For people with ide hard drive, it is a separate batch file to the appropriate channel for direct investment is recommended. Make sure the disk is defragmented, the file is contiguous - more dignified defragmentation utility is so: for example, the full version of the diskeeper. Move the file to disk boot partitions are fully Where You advised that to prevent the creation of system memory dump during the conflict. However, if you want to use just one file and put them in windows 2000 for a separate paging equipment has been installed to provide location is typically the best results. The option to disable the memory dump of Control Panel / System / Advanced / Startup and Recovery write debugging information to set None.

Some adjustments will be recorded in memory can improve performance, the performance of all systems, however, they do not generate income.